Ta strona nie jest jeszcze przetłumaczona i jest wyświetlana po angielsku.
Smoothing, smearing and roughening outlines
The shaping brushes of the Shape flyout reshape the outline of an object where you drag over it, like a sculptor's tool: Smooth, Smear, Twirl, Attract and Repel, Smudge and Roughen.
Using a shaping brush
- Select the curves to change. Other objects are converted to curves first. The brushes change only the selected objects: with nothing selected a drag does nothing, and the status bar says to select an object first.
- Choose the tool and set its Nib size (the radius of the brush, 10 mm at first) and its other settings on the property bar. The nib can also be sized on the drawing: hold Shift, press and drag across (right grows the circle, left shrinks it), or hold Shift and turn the mouse wheel (Alt and the wheel when the wheel is set to scroll instead of zoom).
- Drag over the outline.
The effect is strongest at the center of the nib and fades to nothing at its edge. Only the parts of the outline within reach change; open curves stay open and closed ones stay closed. Each drag is one undo step. The settings are kept for the next time.
Smooth
The Smooth tool removes wobbles and extra nodes where you drag. Rate (1 to 100%, 20% at first) sets how strongly.
Smear
The Smear tool (W) pulls the outline along with the pointer, as if you smeared wet paint. Pressure (1 to 100%, 100% at first) sets how far it moves.
Twirl
The Twirl tool turns the outline around the pointer into a swirl. Speed (1 to 100%, 50% at first) sets how fast it turns, and the direction buttons choose counterclockwise or clockwise; hold Alt or Shift while dragging to turn the other way. Holding the pointer still keeps turning.
Attract and Repel
The Attract and Repel tool pulls the outline inside the nib towards the pointer, or pushes it away, evenly in every direction. Speed (1 to 100%, 50% at first) sets how fast; choose Attract or Repel on the property bar, or hold Alt or Shift while dragging to swap them. It works from the moment you press: holding the pointer still keeps pulling or pushing at a steady pace until the effect is complete, then the outline stays put (Attract gathers it towards the middle of the nib, Repel pushes it out to at most the edge of the nib).
Smudge
The Smudge tool (V) carries the outline under the nib along with the pointer: a stroke that crosses the outline draws it out into a tongue about half as wide as the nib, whose sides run smoothly into the rest of the outline, the same whether the stroke is quick or slow. Pressure (1 to 100%, 100% at first) sets how far the outline follows.
Roughen
The Roughen tool (E) adds jagged spikes along the outline. Frequency (1 to 10 spikes per 10 mm, 5 at first) sets how many, and Spike size (2 mm at first) how tall. The spikes are straight, so they stay sharp. A stroke roughens each part of the outline once: going back over the same place, or holding the button, adds no more spikes. Going over an outline again in a new stroke makes it rougher; spikes that cross the outline stay filled, with no white gaps between them.