Aide de TraceDraw

Cette page n'est pas encore traduite et s'affiche en anglais.

Joining curves

The Join Curves panel closes the gaps between the ends of curves, for example lines that should meet at a corner but stop short of it. Open it with Object > Join Curves.

The Join Curves panel

To join curves

  1. Select the curves. Open parts inside one curve are joined too.
  2. Choose how the ends are joined:
    • Extend: both ends carry on in their directions until they meet, as a corner. When the directions never meet ahead of both ends, a straight line joins them.
    • Chamfer: a straight line between the ends.
    • Fillet: as Extend, then the corner is rounded with the radius (2 mm at first).
    • Bezier curve: a smooth curve that leaves and arrives in the directions of the ends.
  3. Set the gap tolerance (5 mm at first). Ends further apart are not joined.
  4. Click Apply.

The closest pair of ends is joined first, then the next, until no pair is left within the tolerance; the two ends of one part close it. The joined curve takes the place, fill and outline of the curve you selected last, and the other curves are removed. When no ends lie close enough, nothing changes and the status bar says so.

You can also join two end nodes of one curve with the Shape tool; see Shaping curves with the Shape tool. Drawing from the end of a selected curve also continues it; see Continuing a curve.

Join tool

The Join tool, in the toolbox with the Shape tool, joins the end nodes of open curves by hand.

  • Draw a stroke over the end nodes: they are joined in pairs, in the order the stroke reaches them. Two ends within the pick distance of each other become one node halfway between them; ends further apart are joined by a straight segment.
  • Click an end node (it is filled in), then another, to join those two. A click away lets go of the first.
  • The two ends of one curve close it. Ends of two curves make one curve, with the fill and outline of the curve of the first end.

Every join made by one stroke is one undo step. The tool works on the curves of the page that are visible and not locked, outside groups.