Bantuan TraceDraw

Halaman ini belum diterjemahkan dan ditampilkan dalam bahasa Inggris.

Connector lines and anchors

Connector lines join two objects and stay attached to them: when you move or resize the objects, the connector follows. They are useful for diagrams, flowcharts and organization charts.

Anchors

A connector attaches to an anchor of each object. Every object has four anchors, at the middle of each side of its bounding box. You can add your own anchors with the Edit Anchor tool; they move and scale with the object.

Drawing a connector

Three tools in the Connector flyout draw connectors:

  • Straight-Line Connector: a straight line;
  • Right-Angle Connector: horizontal and vertical segments with square corners;
  • Rounded Right-Angle Connector: the same with rounded corners.

To join two objects:

  1. Choose a connector tool.
  2. Drag from one object to the other. While you drag, the anchors of both objects show, and the line starts at the anchor that will be used.
  3. Release on the other object.

When you start or end the drag on an anchor, that anchor is used; otherwise the closest pair of anchors of the two objects is used. The connector is an open line with no fill and the default outline.

Connector settings

The property bar, shown with the connector tools and when the selection is all connectors, has the three kinds of connector (with connectors selected, they change how those run), the corner radius of rounded connectors (3 mm at first), and the outline width, style and arrowheads of the selected connectors.

Staying attached

  • When you move, scale or reshape the joined objects, the connector runs again between their anchors.
  • When you move the connector together with its objects, it stays attached.
  • When you move the connector on its own, it lets go and becomes a plain line. Undo attaches it again.
  • When one of its objects is deleted, the connector stays where it is.

Editing anchors

The Edit Anchor tool adds, moves and deletes anchors:

  1. Choose the Edit Anchor tool and click an object. Its anchors show as diamonds.
  2. Click inside the object to add an anchor there.
  3. Drag an anchor you added to move it.
  4. Select an anchor and press Delete, double-click it, or click Delete anchor on the property bar to remove it. Remove all custom anchors removes every anchor you added.

The four anchors at the middle of the sides cannot be removed.